How To Make a Mason Jar Soap Dispenser - Live Life DIY

745 views · Published 23 October 2017 · 4:50 · Indexed 8 November 2026

Channel: Goose Pond Hideout with Rob · 2017 · Howto & Style

Watch on YouTube

Live Life DIY is about being self-reliant, self sufficient, and independent. You creating a fun, happy, lifestyle of freedom. Live Life DIY is the life you have always wanted to live, your dream lifestyle.

The most excellent way to be supporting Rob and Live Life DIY is to LIKE & FAVORITE & THUMBS UP this video and share it with friends.

Subscribe:  https://www.youtube.com/c/LiveLifeDIY?sub_confirmation=1  *** Be part of the Live Life DIY community.

WebSite:  http://www.LiveLifeDIY.com  
Google+:  http://Gplus.to/CaptRobLee

Do you need to wash your mouth out with soap?

Mason jar soap dispensers are a nice way to decorate and customize your home. 

Let’s get right to it.

Here are the tools I am using to replace the rusty metal lid and ring with a nice white plastic lid. 
This is a quick easy project. 

The first step is removing the super rusty lid and ring. The ring rusts to jar and if difficult to remove. 
Every time you want to add soap the ring is stuck to the jar and I have to use a channel lock to remove it. 

You can see how rusty it is. Not a smart design, cheap metal where it gets wet. So it rusts.

Definitely not attractive for the kitchen or bathroom.
We purchased a few of these inexpensive pumps at a hobby craft store.

You can find pumps at a variety of stores. 
They do make fun dispensers. Better than the commercial plastic labeled bottles. 

This is the new white plastic lid. 
It has a dimple in the center, thankfully, so I don’t have to measure and find the center. 

I drill a pilot hole with a small bit, 
and then make it slightly larger with a second bit.  
The reason I’m doing it this way, 
is to make sure the spade bit drills straight through the plastic lid with wandering around. 

My kit of spade bits runs from one quarter inch to one full inch by a sixteenth of an inch. 
And then it jumps to one and one quarter of an inch. 
The one inch bit is too small and the one and one quarter bit is way too big. 

Unfortunately, I don’t have a one and one sixteenth bit. 
Not a problem. Just adds an extra step. 

Be sure to hold the lid tight. As the spade bit cuts through the lid it will grab the lid and jerk a little. 

The extra step is using the dremel tool with sandpaper to enlarge the hole. 

It doesn’t have to be perfect, because the pump covers the hole. 
It should be just large enough so the pump fits through the hole. 

Clean up the loose shavings. If needed, a little hand sanding would get it nice and smooth. 

Put the pump together through the hole in the plastic lid. 
Finger tight is probably fine. But since I have the tools handy, I’ll give it a little extra tightening. 
And you are good to go. 

A nice looking soap dispenser that won’t rust and look nasty. 

When was the last time you did something new?
Subscribe and be part of the Live Life DIY community.

Thank you for watching my videos. 

The goal is being self-reliant. The goal is being happy while doing stuff yourself.

Be prepared to live happy and live self-reliant.

Now go wash your mouth out with soap.

Live Life DIY.

More from this channel