My Second Plasma Battery

2,216 views · Published 13 December 2015 · 4:56 · Indexed 8 November 2026

Channel: AbbyJo Ovitsky · 2015 · Nonprofits & Activism

Watch on YouTube

I did polarize/calibrate with this same voltmeter (which was used perhaps once on A/C a long time ago thereafter only for this project). I calibrated it at least half a dozen times and used the butane torch up pretty much, all the fuel gone. Meter showed lots of flow during burning. 

This butane torch toasting the outside of the 65 turn coil which is 65 rolled left hand turns using the candy thermometer shaft and a screwdriver extension rod without the screwdriver. The screwdriver shaft is slightly wider and the candy shaft coil goes inside the screwdriver shaft. I connected the wires slightly differently than before. I left a lot of wire on one side so the gravitational cord could go all the way around and out on both coils, then left it as a long "A/C in" which had a red tag on it (now crispy), the short side is the magnetic load side.

Note: bamboo chopstick does not work. It does not burn but it expands and it was very hard to get the wire off the chopstick.

So after rewinding smaller coils (originals were 81 and 162), and toasting the outside, I wanted it darker, had no more butane, so I tossed it inside the pellet stove on top of a large flame on a pile of wood pellets and baked it for at least an hour in there, because I did not want to combine heat & caustic, I wanted one experiment to be heat only, as Mr. K said heat coating is more conductive. When I removed the coil it out was pitch black. 

After doing the above, I dunked it in gans (pistachio coloured kept in covered plastic container) and dried it for a few hours in the only warm room I have. I forgot about paperclips. But seems to work, possibly because I grounded the circuit properly this time. It is a small but growing flow. The flow appears to be triple digits on the battery which is more than the day after I hooked it up, so this has now been set up for about 3 days. If the flow is increasing I would expect it is working. There is no heat around it or in the room, which remains cold. This room is in the half of the house away from the meter/pole and I do have load plugged in between this project and the pole, to compare not this month's bill with 2014 but next month's bill, although it might be interesting to see if November 2015 is a lot lower than November 2014. The true proof there will be consistent reduction in power usage if the cascade is being built up. 

Plan is to take the old coils apart, make the outer ones 144 instead of 162 to achieve Phi ratio, leaving the inner ones at 81; then burn in pellet stove, then to cold water (to remove excess old gans as Mr. K described) torch, calibrate, quick dip in fresh gans (not newly made just unused), dry for 1/2 day, then replace in magrav, also to replace all metal parts with nylon parts, then see if that works. A thin layer of gans dries faster. 

In any event, putting the neutral wire inside the pipe instead of on top of it, seems to close the circuit and make it possible to measure small amounts of current.

Help us caption & translate this video!

http://amara.org/v/H7AU/

More from this channel