MakerBot Replicator 2 PLA Warping with DIY Mini Quad
2,862 views · Published 5 July 2013 · 2:29 · Indexed 12 November 2026
Channel: Dennis Baldwin · 2013 · Education
I wanted to share my recent experience with PLA warping. I have read about PLA having a lower melting point than ABS plastic, but didn't realize it would warp at such a low temp. I'm guessing it was 125-130 degrees F in my car. I've printed a new frame and am now using the Turnigy 1811 2900kV motors, which provide much more thrust than the iPower ones I started with. The Turnigy can only support up to a 2S battery but I can tell this will get the mini quad in the air. Thanks again for all who suggested the Turnigy 1811 series motor!
More from this channel
-
0:59
Skateboarding in 1990
-
2:46
Ublip - A Web 2.0 Spin on M2M Mashups
-
0:58
South Texas Bird Dog Suelou Retrieves and Buries a Wild Quail
-
1:11
Giraffe Feeding at Fossil Rim Wildlife Park in Glen Rose
-
3:50
Volcom Wild in the Parks 2011 Finals at House Park Austin TX
-
2:02
South Texas Quail Survey - Experimentation with Bottom Mounted Go Pro on TBS Discovery Quadcopter
-
2:10
Maiden Quadcopter Flight - DJI Naza Stability Demo w/ Cory Kirk
-
2:10
TBS Discovery and DJI Naza Manual Mode Back Loop Attempts