Renfroe Road Railroad Crossing, Briarfield, AL

3,503 views · Published 9 April 2018 · 2:41 · Indexed 1 November 2026

Channel: freebrickproductions · 2018 · Science & Technology

Watch on YouTube

*originally recorded on 4-2-18*

Signal on the left: 2 pairs of Safetran 12x24 inch lights, 2 pairs of Federal Signal 12x20 inch lights with Dialight Low Wattage LEDs, an NEG electronic bell, an Invensys Rail gate mechanism, and RECO LED gate lights.
Signal on the right: 2 pairs of Safetran 12x24 inch lights, 1 pair of Federal Signal 12x20 inch lights with Dialight Low Wattage LEDs, 1 Federal Signal 12x24 inch light with a Dialight Low Wattage LED, 1 Safetran 12x24 inch light with a Dialight Low Wattage LED, a dead General Signals (Type 1?) e-bell, an NEG e-bell, a Safetran gate mechanism, and RECO LED gate lights.

After catching A714, I went west to the Coosa Pines Siding to watch A714 switching, and to see if there were any other trains coming by checking the signals. While there, I bumped into the same signal maintainer from my previous trip to this area, and after a while of talking, he decided to pull up the ATCS feed for me, where we saw that a west(north)bound was leaving Talladega, so I went back over to this crossing. Sure enough, a few minutes later this mixed freight came roaring through with an ES40DC leading a Dash-8. Would've prefered the Dash-8 to be leading, but I'm just glad to see that CSX still has some right now.

This crossing is certainly unique. First off, the Federal Signal lights here are an older, much rarer variety with a smaller logo on the back (that also sticks out a bit, whereas the more common ones have the logo inset a bit). The left-hand signal used to have a WRRS mechanical bell back in 2015, but sometime more recently the bell was replaced with an NEG e-bell. The gate mast for that signal also used to have an old WRRS gate mech and some 8 inch lights, but CSX had replaced those with the current equipment by 2013. The right-hand signal also appears to have had its original gate mast replaced in the early to mid 2000s, oddly enough with a mast that appears to have been meant for a crossing without cantilevers as it has mounts where some lights used to be. The mast also used to have a General Signals e-bell when it was originally installed, but it was replaced by 2013 with the current NEG e-bell. I'm also not sure why the e-bell on the cantilever would be replaced so soon after it would've been installed in the late 90s or early 2000s. Seems like a bit of a waste to me. Speaking of the abandoned e-bell, the speaker on it has fallen into the speaker chamber in two pieces. There's also a slight delay between the two gate mechs beginning to lower. Interestingly enough, this crossing is just north of ALDOT's official end of AL 235 at CR 190 and CR 191 (which is the road this crossing's on), but apparently CSX believes that AL 235 goes all the way up to the crossing.

More from this channel