Mill power feed sheave

2,995 views · Published 17 November 2013 · 4:09 · Indexed 8 November 2026

Channel: Shadon HKW · 2013 · Education

Watch on YouTube

I have already gotten a few PM's about the drive set up on my mill, this was a shop made rig, this photo series walks you through the whole process.

It uses a Gast .33 HP gear reduction air motor.

It sure beats cranking the table up and down by hand.

More from this channel

• 3:25 DoAll mill tour

  Shadon HKW

  2,237 views · 17 November 2013

• 14:10 Johnson bandsaw model B rebuild part 2.5

  Shadon HKW

  4,441 views · 22 November 2013

• 11:32 Tool review #1

  Shadon HKW

  2,878 views · 22 December 2013

• 11:36 Honey do #1

  Shadon HKW

  2,545 views · 23 December 2013

• 14:15 Tool storage and care

  Shadon HKW

  3,073 views · 30 December 2013

• 2:21 Plasma cam failed cut

  Shadon HKW

  3,387 views · 6 January 2014

• 4:42 One piece angle square #1

  Shadon HKW

  2,827 views · 7 January 2014

• 6:38 Paint spray booth and convection oven for waterborne coatings #2

  Shadon HKW

  2,198 views · 30 January 2014