Tool-post clone - another approach
3,409 views · Published 29 October 2013 · 6:57 · Indexed 6 November 2026
Channel: ChrisB257 · 2013 · Science & Technology
(**Have found a local option to mill off the material - watch out for hopefully more progress later**.) Following the previous item on cloning a 4 way tool post - http://www.youtube.com/watch?v=RQpqLMnYuhQ - that finished up by being abandoned due to slow material removal. Then too, an acquisition of a new quick-change tool post pretty much aborted that project! Here however we just tried using a small fly cutter as a means of material removal to see if it had any advantages over previous use of just end mills in the lathe. It works but, again stock removal is tedious and, due to workpiece mounting considerations (inadequate total rigidity etc) max cut per pass is rather limited. This may be worth pursuing over time but what is needed is a good solid milling machine -- something I have long been without and so, trying to do everything in the lathe! If things do go further we'll add more video later.
More from this channel
-
8:52
Pt 1 of 2 - The Second Amendment - its Slow Demise
-
9:54
Pt 2 of 2 - The Second Amendment - its Slow Demise
-
5:40
FlyCamOne2 - Memorial Day 2008
-
8:28
More FlyCamOne - 4 star
-
2:19
FlyCamOne - dead stick short flight
-
6:47
FlyCamOne - 4 Star 60
-
9:53
FlyCamOne - 4 Star 60
-
8:31
FlyCamOne - Uproar 40 aerobatics