Stratasys - Injection Molding vs. Direct Digital Manufacturing

2,694 views · Published 23 May 2011 · 26:15 · Indexed 1 October 2026

Channel: GoEngineer · 2011 · Science & Technology

Watch on YouTube

Learn about injection molding versus direct digital manufacturing in this presentation. Low-volume manufacturing can mean producing anything from 1 part to 5,000 parts. In some cases, it's possible to reduce low-volume production costs by 75% or more, by replacing traditional tooling with direct digital manufacturing (DDM). But DDM isn't for every application. Determine if this alternative process is right for your company by watching this presentation.

Video re-posted with permission from Stratasys.

More from this channel

• 4:05 SOLIDWORKS Rx

  GoEngineer

  2,003 views · 22 May 2010

• 7:12 SOLIDWORKS - Introduction Pt. 5 of 5

  GoEngineer

  3,405 views · 27 May 2010

• 2:56 SOLIDWORKS - Enclosure Design Around Moving Parts

  GoEngineer

  4,079 views · 10 March 2011

• 5:37 SOLIDWORKS - Mass Driven Feature Definition

  GoEngineer

  1,979 views · 16 June 2011

• 7:02 Stratasys - Tape Wrangler Case Study

  GoEngineer

  1,245 views · 17 August 2011

• 28:02 Stratasys - 7 Ways to Take Advantage of Additive Manufacturing

  GoEngineer

  2,876 views · 17 August 2011

• 2:12 SOLIDWORKS 2012 - Leave Changes & Custom Properties

  GoEngineer

  4,962 views · 8 September 2011

• 2:07 SolidWorks Simulation - Duplicating a Study

  GoEngineer

  3,586 views · 15 September 2011