Stuart Turner N3 Restoration - Part 26 - Test run 3
1,159 views · Published 14 March 2015 · 4:23 · Indexed 10 November 2026
Channel: steamwally · 2015 · Entertainment
At last, the engine has run for an hour without my intervention to keep it going. It looks like the carburetor is going to have to be milled so that it sits "square" to the engine, at present it's set up for running in a boat; where the engine would be at an angle. A bit more tinkering needed yet, but it gets better with every minute it runs. This engine was built around 1935, the third last of around 1400 N types made before the R2 and R3 took over. Interestingly, the output of this one is un stamped, but it is thought to be around 3/4hp at the rated speed of 1500rpm. I acquired the engine in July 2012, it has required all bearings, piston rings, a connecting rod and gaskets replaced as well as virtually every other moving part repairing in some way - be it adjusting the fit or boring and sleeving to compensate for wear - it must have been really abused! In it's final working days, the connecting rod bearing was so worn that it was hitting the crankcase....