Aristo-Craft Mallet on Ted's layout with Kadee couplers.

1,144 views · Published 11 June 2015 · 16:38 · Indexed 19 October 2026

Channel: gregeusa · 2015 · Entertainment

Watch on YouTube

This video is about my (Ted Doskaris) Aristo-Craft Mallet Loco with Vanderbilt tender having been fitted with Kadee centerset couplers running for the first time on my  outdoor layout.  The loco itself (fitted with a Kadee 907 coupler with modified Kadee box) had to have its front pilot reinforced with a thin steel "U" strap attached over the coupler post (along with the mounted box) at one end and the front motor block at the other end to ensure enough strength so the pilot would not pull off under load since the pilot is only held in place by two tiny screws.  The strap is an inverted "U" shape (with offset horizontal mounting ears) so when the front pony truck pivots on curve tracks it will go within the "U" opening.

The Vanderbilt tender with its 3 axle Commonwealth trucks was lowered 0.160 inch to be prototypically realistic.  Lowering was accomplished by modifying the trucks.  The Commonwealth truck lent itself to doing this very easily since its bolster between the side frames was merely flipped over and re-attached from the underside, though wheel flange clearance had to be accommodated by beveling the "H" legs of the bolster.  A rectangular pocket in the flipped bolster allowed for placing a shim of appropriate thickness to achieve the 0.160 inch lowered tender.  The loco side of the tender was fitted with a body mounted thin steel "S" bend strap to serve as the anchor for the loco's draw bar connection, thereby, replacing the truck mounted bar.   The tank end of the tender was fitted with a Kadee 905 centerset coupler on a right angle steel bracket.  This bracket only needed to be held by the one long screw at that end of the car since the bracket was made to conform to the triangular shape of the plastic underframe.  This mounting method proved to be very rigid.

More from this channel