Bending metal with Lincoln electric mig welder
735 views · Published 2 August 2018 · 1:34 · Indexed 20 September 2026
Channel: NOBOX7 · 2018 · Science & Technology
This video contains Paid links that gives me a 6% commission if you click and buy any product on that website . This video contains Paid links that gives me a 6% commission if you click and buy any product on that website . Check out my web site http://www.nobox7.com/ Check out my store front https://www.amazon.com/shop/nobox7 Support this channel on Patreon https://www.patreon.com/user?u=3620781 Building a third hand tool Techniques It may prove impossible to bend a piece of rebar by hand, but with the extra leverage of a rebar bender, you can easily bend these tough steel rods into nearly any shape. But it takes a little knowhow to get the measurements right. The following bending and cutting techniques can help you to get it right the first time: Measuring- Always measure at least 3” more than you need to prevent being short on the overall length and lap. It’s always better to have more steel overlapping than not enough. Also, when you place the rebar into the bender, move the handle to where the bender arm engages with the steel—and your measurement. This will help you get an accurate bend every time. Bending- All rebar has a seam on each side of the steel. This seam should be placed on its side when making a bend or else you’re going to have a difficult time making a good bend. A framing square can verify that your 45 degree angles (the most common bend) are right on the money. Multiple Bends- Sometimes you need to bend a piece of rebar with two bends on one piece of steel. This can be nearly impossible if you don’t have someone else holding the other end of the rebar in exact position. Without a helping hand for this job, you might want to consider cutting and lapping the rebar instead of making a multiple bend.
