Fixing an Aristo Wide Radius Turnout and testing it in an 8 ft. dia. circle by Ted Doskaris.
1,023 views · Published 11 February 2014 · 15:07 · Indexed 14 November 2026
Channel: gregeusa · 2014 · Entertainment
Fixing an Aristo Wide Radius Turnout and testing it in an 8 ft. dia. circle by Ted Doskaris. The Aristo WR turnout has a 10 foot diameter diverging path but this turnout can be used in an 8 foot diameter circle of track. The diverging path is almost the same length as an Aristo 8 foot diameter track section. The turnout path curvature is so little different from an 8 foot section of track as to be virtually unnoticeable. Aristo turnouts typically have problems right out of the box. In this case I remedied a stainless steel Wide Radius turnout. It has a 5 foot radius (10 foot diameter) diverging path. One fix entailed removing the molded-in plastic guard rails, replacing them with metal ones obtained from a section of track. (The plastic guard rails are spaced too far from the stock rails and have abrupt transition ramps.) Replacement metal guard rails are custom cut to be longer and bend with smoother transition ramps and mounted so as to raise them about 0.015 inches higher than the adjacent stock rails. The guard rail's closer spacing of 0.106 inch (NMRA spec.) from the stock rails prevents a wheel flange from the opposite end of an axle from striking the frog point. The metal guard rail with smoother ramp transitions and higher mounting alleviates the tendency of a loco wheel from riding up on it. The other fix concerned the swinging point rail of the diverging path. When a loco would attempt to go through the turnout facing that point rail, its wheel would tend to ride up over it and then the loco would derail. Examining the point rail showed it was ever so slightly too far from the stock rail. The cause is due to the cross section shape of the stock rail that it is not straight up & down but tapered toward the track ties (sleepers) such that when the point rail is against it there is a gap at the top. The gap is not too noticeable with the naked eye, but very noticeable when using a magnifying glass. The solution is to grind the taper off the side area of the stock rail where the point rail meets it so that it is vertical whilst being careful not to grind into the rail's head. This allowed the point rail to be positioned closer to the stock rail with minimal gap.
More from this channel
-
0:57
My Layout - 7 car passenger train on 5% downgrade
-
0:20
My Layout - long train through "canyon"
-
1:20
My Layout - Coming down the grade
-
2:14
My Layout - main line on north side
-
1:20
My Layout - inner to outer loop with long freight
-
0:21
My Layout - passenger train in canyon
-
2:14
My Layout - side yard and downgrade by back of house
-
1:42
Aristo-Craft GP40/SD45 Reefer Block Train with Kadees