Time Lapse: Frame for the Open Source Ecology 3D Printer

2,222 views · Published 2 March 2017 · 0:29 · Indexed 31 October 2026

Channel: Marcin Jakubowski (Open Source Ecology) · 2017 · Science & Technology

Watch on YouTube

This is frame making for the OSE 3D printer. Mild steel, 10 gauge.

In the video above, JB Weld Epoxy is used. It took one hour, and indicates that bolting the frame using angle brackets would be much quicker - but additional parts and screws will be needed. The bolted route should be tested for speed and accuracy of fit. The nice thing about the epoxy route is that the finish is clean and the cube looks good.

The video above is 28 seconds, taken at 10 second intervals, 25 frames per second. 28x25x10/60 = 117 minutes in actual time. 

The first 15 seconds are an attempt to glue with crazy glue, which just doesn't work. The last 13 seconds are the JB-Weld route., which takes significantly longer than just welding. 13*25*10/60= 54 minutes. 

About one hour (not including the 6th frame member - appears to be much longer than just bolting with 2 angle brackets per edge. Advantage is a very clean frame.

The alignment was done by using 1" angle with 12x3 mm N52 supermagnets  - to hold the frame in place while gluing.

This frame is cut from 10 gauge steel, and it gives insight that simplified Power Cube (http://opensourceecology.org/wiki/Power_Cube)can also be made in this way much more quickly than using steel angle. The steel angle route requires measuring and precise cutting, as well as more difficulty in alignment. Using the plates, square alignment is already established, and cubic alignment is established simply by having the corners of 6 sides touch each other. So assembly could be much quicker.

Take a minute to subscribe to our email newsletter (updates, workshops, etc): http://bit.ly/1LtcM44

More from this channel