Blazer's First New Engine Drive - VLog 293, 03/15/2018

165 views · Published 21 May 2018 · 13:59 · Indexed 25 October 2026

Channel: AK49BWL · 2018 · People & Blogs

Watch on YouTube

03/15/2018
As someone who has been basically slowly rebuilding this entire truck for the last three months or more, I can very well say I am extremely excited to have it running and driving again! A lot has gone into getting it to this point...

What's changed since I bought it?

Pre-engine removal:
Door locks, ignition cylinder now matching (given key only worked in ignition)
New tie rods, ball joints, center link, wheel bearings, idler arm
New catalytic converter (original was completely plugged)
New set of Goodyear Wrangler P235/75R15 Tires

Machine shop engine rebuild consisted of:
New main bearings, rod bearings, piston rings, cam bearings, balance shaft bearings, lifters, timing chain and sprockets, milling of the crankshaft and heads, valve body resurfacing

Post-machine shop:
New Felpro head gaskets, valve stem seals, metal-frame lower intake manifold gaskets, oil pan gasket, rear main seal and gasket, all upper intake manifold gaskets, water pump gaskets
New timing cover
Lower mileage ignition coil, distributor shaft, upper intake manifold, all vacuum lines, 4L60E transmission, oil filter adapter and cooler lines (parts given to me by a friend in Fort Worth)
New bank 1 o2 sensors
New distributor rotor, cap, wires, NGK spark plugs
New power steering pump, steering gearbox
New radiator, A/C condensor, A/C evaporator, heater core, blower fan
2000 Camaro 3.8 Electric Fans fabricated to fit, engine-driven fan permanently removed
New 200amp AD244 alternator

Misc:
LED lighting throughout interior, exterior - Factory fog lights installed using wiring harness from 1998 GMC Jimmy, new blinker housings
New lift cylinders for rear window
Interior seats, carpet, trim completely removed, cleaned, reinstalled (well mostly lol)

There are probably several things I've forgotten, and still more I have yet to do, but that's the main bit of it.

Used in the making of this video: Canon PowerShot SX230-HS Red

More from this channel