Design Experimentation of 3D Printed Vibration Mounts for GoPro Hero with TBS Discovery Quadcopter
2,200 views · Published 17 March 2013 · 1:41 · Indexed 12 November 2026
Channel: Dennis Baldwin · 2013 · Education
This is just an experimental video I wanted to share. I've been working on a few designs using Rhino 3D and my MakerBot Replicator 2 to come up with some ideas for vibration dampening mounts and my GoPro Hero 2. This is what I'm calling the "earplug mount" for my TBS Discovery, which consists of two 3D printed plates separated by six foam earplugs. I'll continue to post some different design concepts as well as the actual results from each mount. My goal is to come up with an effective and simple design that I can share with the multirotor community. If you have any ideas or suggestions then please post in the comments below. Also, please join our multirotor community at www.garagepilots.com
More from this channel
-
0:59
Skateboarding in 1990
-
2:46
Ublip - A Web 2.0 Spin on M2M Mashups
-
0:58
South Texas Bird Dog Suelou Retrieves and Buries a Wild Quail
-
1:11
Giraffe Feeding at Fossil Rim Wildlife Park in Glen Rose
-
3:50
Volcom Wild in the Parks 2011 Finals at House Park Austin TX
-
2:02
South Texas Quail Survey - Experimentation with Bottom Mounted Go Pro on TBS Discovery Quadcopter
-
2:10
Maiden Quadcopter Flight - DJI Naza Stability Demo w/ Cory Kirk
-
2:10
TBS Discovery and DJI Naza Manual Mode Back Loop Attempts