SubElement Select - Architectural Prototyping with Rhino 5 and Grasshopper | Black Spectacles

4,963 views · Published 27 January 2016 · 3:42 · Indexed 10 November 2026

Channel: Black Spectacles · 2016 · Education

Watch on YouTube

To view the entire course, click here:
http://bksp.es/yt-rhino-5-and-gh 

One thing you can do however, with polysurfaces if you need to modify them, is you can start selecting individual elements and these commands are not new to Rhino but there is a way of interacting with them that is new. 

If you hold the "shift" and "control", that toggles sub-element selection. You'll notice if I left click on my geometry here, it's going to select the whole thing. But if I hold shift and control, this is just going to select an individual piece. 

And what I can do is I can move that thing around a little bit. And in some cases it's going to mess with the geometry, so use it with caution. If you're doing planar transformations to your geometry, it is a pretty useful tool.

So what I can do is I can hold shift and control and perhaps select this edge and it's going to affect the result. So I can select multiple elements here, so it's transforming sub-objects, I'm just going to hit "escape" to cancel that because the transformation is probably doing something that was generating thousands or tens of thousands of new control points and we want to avoid that. 

I can also do things like scale my sub-elements and that will affect the resulting polysurfaces. This is actually starting to look like a pencil. So if I pull this thing down a little bit more, and there we go. It started what looks to be a pencil. And this is where the graphite would go.

Again, to select the sub-elements of a piece of geometry, you hold shift and control. Alternatively you can enter these commands manually and these have existed in Rhino for some time. So you can use the "move edge" command and what that's going to do is that's going to prompt you to select an edge and then it will prompt you for a move point.

So I'm going to select a point here. I'm going to hold "control" and click that point which will toggle on vertical transformation mode and I'm just going to move that myself.

Likewise I can also use the "MoveFace" command which will actually take this whole face and move it up and down. So again using the "control" key to toggle vertical transformations on and off, and that's basically it for sub-elements.

I want to cover a couple more things before we move on to some of the fabrication content for this lesson. So one is, and this is getting into sculpting our polysurfaces a little further. So I'm going to copy my weird pencil/straight table leg here. Actually let's do this. Let's flip this upside down and then move this vertically, and turn on the near, turning on the near objects snap option and that will basically lock my cursor to any point on a curve or an edge.

More from this channel