Implementation of an Aristo Revolution Base Station with Switchable PWC to Linear Output
416 views · Published 27 August 2013 · 13:20 · Indexed 19 October 2026
Channel: gregeusa · 2013 · Entertainment
Though the Aristo Revolution transmitter includes a command means to set PWC or Linear, the receiver hardware does not support it - not even to the extent of having a dedicated connector pin that a user could make use of when employing the optional PWC to Linear board. A work-around solution is to use one of the pins on the receiver's Auxiliary connector to remotely control a 15 amp relay (that is wired between the receiver board and PWC to Linear board) to switch it when the corresponding transmitter numeric button is actuated. The numeric button is programmed to function in a latching fashion so the relay will stay in its commanded state until the button is again actuated, thus toggling the relay on / off / on, etc. A relay driver circuit is required to provide sufficient current to reliably drive the relay coil since the receiver board open collector transistor is too marginal in current sink capability. A video by Ted Doskaris
More from this channel
-
0:57
My Layout - 7 car passenger train on 5% downgrade
-
0:20
My Layout - long train through "canyon"
-
1:20
My Layout - Coming down the grade
-
2:14
My Layout - main line on north side
-
1:20
My Layout - inner to outer loop with long freight
-
0:21
My Layout - passenger train in canyon
-
2:14
My Layout - side yard and downgrade by back of house
-
1:42
Aristo-Craft GP40/SD45 Reefer Block Train with Kadees