New Spindle's First Cut - CNCnutz Episode 144
4,307 views · Published 16 April 2017 · 4:07 · Indexed 1 October 2026
Channel: CNCnutz (Peter Passuello) · 2017 · Entertainment
This is the first run of the new spindle. New and improved with start, stop and speed under software control. Hadn't intended to go this far with the build but things got away on me and before I knew it I had built a new controller housing for the VFD and moved my Gecko drive into it as well. www.cncnutz.com SHARE WITH OTHERS: https://www.youtube.com/user/cncnutz SOCIAL: www.cncnutz.com Email: [email protected] https://www.youtube.com/user/cncnutz https://www.facebook.com/CNCnutz https://twitter.com/cncnutz DISCLAIMER: CNC machines and other power tools are dangerous when used incorrectly. These videos are for entertainment purposes. I can accept no responsibility for any injuries you may incur from replication of what you see in these videos. I aim to demonstrate safe procedures but before attempting any project you should have prior machining experience or have done further research. If you are in any doubt about your safety you should look for an alternative method. I hope you enjoy.
More from this channel
-
2:34
Cutting the new Y axis video
-
6:52
Experiment in spindle cooling Twin Turbo Router - CNCnutz Episode 10
-
8:58
Tabletop Q&A - CNCnutz Episode 103
-
6:56
The Secret life of ORings - CNCnutz Episode 117
-
10:52
DIY Cable Management - CNCnutz Episode 137
-
2:48
Javi's Almost Impossible Challenge Day 2 - CNCnutz Episode 167
-
3:06
Javi's Almost Impossible Challenge Day 23 - CNCnutz Episode 189
-
2:59
Javi's Almost Impossible Challenge Day 27 - CNCnutz Episode 193