Air Cannon #46 - Barrel Sealing Piston Valve Cannon

3,820 views · Published 4 April 2013 · 6:09 · Indexed 18 November 2026

Channel: Bill Gilmour · 2013 · Science & Technology

Watch on YouTube

This one got made up from odds and ends. Starting with a small disposable propane tank and some 3/4" pipe fittings including a tee, I made up a barrel sealing piston valve cannon. Aluminium fittings were machined from scrap 6061 for each end of the valve. The piston is 0.820" diameter. It has a spring behind it that pushes it to the closed position after each shot. This cannon is filled at the air chamber rather than through the valve. The piston valve is currently activated by a 3/8" ball valve. This cannon can use the same interchangeable barrels that my other cannons use. At the end of the video, I found a bad tube of caulking so I put on the 2" barrel and fired a caulking tube about 150 meters across the farm field, The tube was about half full and heavy, or it would have gone further. Unfortunately the camera did not pick up the tube in flight, maybe if I paint the next one fluorescent green or orange then the camera will see it in flight. I will try this again. This cannon works well. A 360 grain .565 cal slug fired at 300 psi from the 45" barrel will have about 550 fps velocity.

More from this channel