2.4 GHz WiFi Slot Antenna Photos With Dimensions

3,212 views · Published 5 December 2016 · 0:34 · Indexed 1 November 2026

Channel: ElPaso TubeAmps · 2016 · Entertainment

Watch on YouTube

I built this slot antenna several years ago and  have used it with very good results in illuminating a parabolic dish for 2.4 GHz. My intention  for posting just pictures with dimensions is for others that may be considering building such a device and would rather have empirical data instead of theory. I have another video on this slot antenna if you are seriously interested in building one and need a little more information on how it is constructed:  https://www.youtube.com/watch?v=T_Lq9_yzlKE#t=11.663021

Additional information 6/24/2017
I can't remember for sure of the exact article and date  but in any case, the article I mention was terribly inadequate and left me very confused all those decades ago. It took a lot of research through books back then and no one to talk to about it like we now have with YouTube and the Internet. Fortunately, I did have the WSMR technical library to do research. If you pause on the video I posted with the pictures and study each, I believe you can get a pretty complete picture of how it is built.

Notice that one side of the dipole is mounted just through the outer wall of the copper water pipe but goes just inside the copper water pipe no deeper than the thickness of the wall of the pipe and is soldered.

The other side of the dipole goes through the pipe and actually attaches directly to the inner conductor. For a DC ohm meter this thing is one complete dead short anyway you measure it but it works great at 2.4 GHz.

Also notice that the center conductor attaches to the 4 inch reflector and is actually drilled and tapped for a 6-32 screw that holds it to the 4 inch disk, plus being soldered.

The end of the inner conductor which connects to the male "N" connector is tapered for about the last 3/4 inch where the male pin is soldered and then inserted into the N connector on the end of the pipe. The length of the feed line is not important but should be kept short as possible. Exacting dimensions are a real challenge in making this device. Take a small file and make this N connector connection all tapered and smooth.

There is no "common sense" it its construction as far as DC analysis goes.

I posted these videos because there is such an inadequate amount of information available and I am pleased that the video is found to be of value.

David
WA4QGA

More from this channel