DIY Twin Engine Tundra RC Plane Build - Part 2 (Installing Nacelles and Electronics in Fuselage)

1,441 views · Published 17 September 2018 · 13:50 · Indexed 4 November 2026

Channel: Dave Merc Productions · 2018 · Science & Technology

Watch on YouTube

DIY Twin Engine Tundra RC Plane Build - Part 2 (Installing Nacelles and Electronics in Fuselage) https://youtu.be/fJTWzTuW1TE
You can build your own twin prop tundra using 3D printed nacelles designed by barndog726 (link below). In this video I show how to glue on the 3D printed nacelles onto the wings and install the power system for the differential thrust into the fuselage.

Twin Tundra Build Part 3 here: https://youtu.be/wfvZpO-cgRo
Twin Tundra Build Part 1 here: https://youtu.be/6ltusxU6Su8
And The Introduction here: https://youtu.be/qVKOGMDyM2E

Parts you will need for the build:

HobbyKing Durafly Tundra Kit
https://hobbyking.com/en_us/durafly-tundra-1300mm-arf-orange-grey.html

3D Printed Nacelles bardog726 Thingiverse
https://www.thingiverse.com/thing:3092358

Foam-Tac or Fabric-Tac from Wal-Mart to glue on nacelles.

18 Gauge Silicone Wire to extend motor leads

Battery Turnigy Graphene 2200mAh 4S 65C Lipo Pack W/XT60

Servos 6x TGY-50090M Analog Servo 20T MG 1.6kg

APC 7x5 LP07050E Thin Electric Propeller
APC 7x5 LP07050EP Thin Electric Pusher Propeller

2x Motors SunnySky X2212-KV1400 II

2x ESC 30 amp 2-4s w/ 0.5 amp BEC (Afro)

FrSky X8R Receiver

FrSky FLVSS Lipo Voltage Sensor FRS3040611

XT60 Connectors RC Yellow

HXT 3.5MM CONNECTOR FOR MOTOR/ESC (12PC)
     https://hobbyking.com/en_us/individual-hxt-3-5mm-connector-for-motor-esc-12pc.html

RCgroups Thread
https://www.rcgroups.com/forums/showthread.php?2413887-Durafly-Tundra/page1462

More from this channel