Addendum 1 MinNaza OSD Project (sort of Part 4) Voltage and LED Status Display

4,738 views · Published 15 March 2014 · 8:41 · Indexed 4 November 2026

Channel: Dave Merc Productions · 2014 · Science & Technology

Watch on YouTube

This is an update to the 3 part series on the MinNaza OSD project and a box opening of PoLoLu stuff. More detail on the Voltage display and the LED Status/Flight Modes display as well.

This is based on the MinNaza project wiki:
https://code.google.com/p/minnazaosd/wiki/Intro

See Part 1 here:
http://www.youtube.com/watch?v=k9r_Yu9U5rk

See Part 2 here:
http://www.youtube.com/watch?v=qWOkQqWlmiM

See Part 3 here:
http://www.youtube.com/watch?v=4Zf9QO-sk9E

Addendum 2
http://www.youtube.com/watch?v=vzMJxANCjJM

Battery Voltage resistor divider calculation:
(This is only if you are not using a current/voltage sensor and want to measure the voltage straight from the flight battery).
The recommended resistor divider is 10 to 1 (47k ohms over 4.7k ohms) but this only works with a voltage/current sensor.The target voltage on the output of the divider should be about 0.825 dc volts for a 3s battery (1.1vdc for a 4s battery using the provided firmware).
Formula is R1 = R2 x (Vin/Vout - 1).  For a 3s battery R1 = 47k x ((12.6/0.825)-1) = 670k.
So if you use a 47k on the bottom (R2) you would need a 670k on the top (R1).
Keep in mind it's hard to find exact matching resistors so you might have to experiment.
For example with my 4s LiPo battery I ended up with 680k for the top resistor and 47k for the bottom resistor. (see video for diagram). I later changed the 47k to a 48k (by adding a 1k in series with it) for a closer reading.

-~-~~-~~~-~~-~-
Please watch: "Runcam Owl Plus Camera with Low Light PL0075 Lens Installed for Night FPV RC Flying" 
https://www.youtube.com/watch?v=J5CrWcX20P8
-~-~~-~~~-~~-~-

More from this channel