MY SPOT WELDER 3of5 ASSEMBLE

909 views · Published 21 February 2018 · 16:23 · Indexed 14 November 2026

Channel: Fenyutas · 2018 · Howto & Style

Watch on YouTube

Subscribe:
 https://www.youtube.com/fenyutas?sub_confirmation=1
More videos:
 https://www.youtube.com/user/Fenyutas/videos?flow=grid&view=0

MY SPOT WELDER 1of5 TRANSFORMER
 https://youtu.be/dhwOHNivA9E
MY SPOT WELDER 2of5 WIRING DIAGRAM
 https://youtu.be/b5kCIhH-KzY
MY SPOT WELDER 3of5 ASSEMBLE
 https://youtu.be/lOLa1NIceZc
MY SPOT WELDER 4of5 TEST
 https://youtu.be/IvoyjuY_M0Q
MY SPOT WELDER 5of5 PRESENTATION
 https://youtu.be/loX_rcnXPVg

Resistance spot welding (RSW)[1] is a process in which contacting metal surface points are joined by the heat obtained from resistance to electric current. It is a subset of electric resistance welding.

Work-pieces are held together under pressure exerted by electrodes. Typically the sheets are in the 0.5 to 3 mm (0.020 to 0.118 in) thickness range. The process uses two shaped copper alloy electrodes to concentrate welding current into a small "spot" and to simultaneously clamp the sheets together. Forcing a large current through the spot will melt the metal and form the weld. The attractive feature of spot welding is that a lot of energy can be delivered to the spot in a very short time (approximately 10–100 milliseconds).[2] That permits the welding to occur without excessive heating of the remainder of the sheet.

The amount of heat (energy) delivered to the spot is determined by the resistance between the electrodes and the magnitude and duration of the current.[3] The amount of energy is chosen to match the sheet's material properties, its thickness, and type of electrodes. Applying too little energy will not melt the metal or will make a poor weld. Applying too much energy will melt too much metal, eject molten material, and make a hole rather than a weld.[4] Another feature of spot welding is that the energy delivered to the spot can be controlled to produce reliable welds.

More from this channel