Combo Press and Steady Fingers - More ...

1,535 views · Published 8 March 2015 · 7:35 · Indexed 19 November 2026

Channel: ChrisB257 · 2015 · Science & Technology

Watch on YouTube

Couple of small tweaks made to the press and, almost decided on approach to steady finger modifications.

Now have slightly more pressure on the press shear ''keeper bar'' - may yet find stronger springs if need be.  Managed to set the shear dies a fraction higher - thus allowing a 360º full rotation of the handle as it goes over center on the cam. That means ability to continue a rolling operation pass completely, without affecting the full operation of either the break or the shear - will yet re-check with packing in break both ends. Unlikely the break operation will be needed often for super thin material - if so - just a quick reset can be done.

Steady fingers - decided now almost for sure to reverse the fingers and mount roller cams on other end ... it'll be a fairly quick fix in order to see it it works OK, even tho the vector forces will not be totally ideal perhaps. This was one commenter's suggestion, but forget yet who came up with it. Still, always the option make new of course!

More from this channel