14.153, 14.214, 14.275, 14.336 MHz WiFi RF Interference On Amateur 20 Meter Band

3,332 views · Published 4 May 2017 · 29:59 · Indexed 14 November 2026

Channel: ElPaso TubeAmps · 2017 · Entertainment

Watch on YouTube

******************************************************************************************************
Update 12/15/2021
Four years ago I posted this video and thought I had it defined perfectly. For whatever reason tonight I connected up my HP spectrum analyzer and a "sniffer" probe and started working around the Ethernet switch in the room with my radio equipment. I quickly discovered it was only one cable where I could see the RF noise on my SA. To get to the point - examining the RJ-45 I noticed that I only had the two necessary pair of wires connected - pins 1, 2, 3 and 6.  That is typically the orange and green twisted pair. I did not have the blue and brown twisted pair connected in my RJ-45. I decided to replace that connector and completely solved the problem I have had for years. I can no longer see it on the SA and I can not hear it on 20 meters. I would have never guessed those two unused twisted pair would have been used (apparently...) to serve as a shield and keep the cable from radiating.

******************************************************************************************************

My determination of the digital noise on the 20 meter band being switch mode power supply noise was wrong.  It is a combination of cables and equipment running the 100 MBit CAT-5 Ethernet network.

YouTube has eliminated the ability to add annotations and speech bubbles so I can't correct or add to anything I have said so...

My apologies for this video being so long and redundant but I think it has addressed the real problem this time. It seems a good idea to (1) keep radio coax away from CAT-5 cable (2) don't make any more cable runs than are necessary and keep them as short as possible to get the job done.(3) if possible, from the beginning of installation of any network Ethernet cables that are going to be anywhere around RF amateur radio equipment , use shielded cable instead of UTP.

More from this channel