Install new motor mount on 1984 Pontiac Iron Duke

3,235 views · Published 4 November 2012 · 1:56 · Indexed 10 November 2026

Channel: Tyler's Neighborhood Garage · 2012 · Autos & Vehicles

Watch on YouTube

To do this you need to unbolt one end of the upper torque strut.

Then, jack the car up, support it with a jackstand and remove RF wheel. Remove the 4 nuts that attach the motor mount to the car and engine.

Using a wide block of wood to distribute the load evenly, carefully jack the engine up with a jack. You may have to experiment with car and jack heights to get the engine up far enough. Remember to NEVER get underneath the car without 1 or more jackstands underneath supporting the vehicle.

Slip the old mount out, and reverse the steps to install the new mount.

More from this channel

• 0:51 Trip to Florida part 1

  Tyler's Neighborhood Garage

  424 views · 10 February 2010

• 1:26 Chevy 305 TBI oil level check

  Tyler's Neighborhood Garage

  726 views · 11 February 2010

• 4:35 Warm-up and rev the '78 Bonneville

  Tyler's Neighborhood Garage

  2,456 views · 13 February 2010

• 8:04 1980s Emerson boombox with integral television

  Tyler's Neighborhood Garage

  3,485 views · 13 February 2010

• 6:33 Driving the '83 Isuzu diesel I-Mark

  Tyler's Neighborhood Garage

  4,842 views · 22 February 2010

• 7:29 Heading to Orlando the scenic route

  Tyler's Neighborhood Garage

  429 views · 3 March 2010

• 0:46 1995 Chevy van the day we hauled it home

  Tyler's Neighborhood Garage

  2,535 views · 21 March 2010

• 8:31 Rainy day Buick Roadmaster drive Part 1

  Tyler's Neighborhood Garage

  1,329 views · 28 March 2010