TronxyX5S testCube 50x50x50 - need advice
1,750 views · Published 27 November 2017 · 2:23 · Indexed 25 October 2026
Channel: theBreadboard · 2017 · Science & Technology
So I downloaded this test cube from Thingiverse https://www.thingiverse.com/thing:1278865 I sized it to exactly 50x50x50mm and printed it with the following parameters Orange PLA 50 deg C bed on first layer, down to 40 after that 210 nozzle then down to 200 speed about 60mm/sec The basic quality was very good but there is a very fine line just where the text starts and again where it ends, the cube is marginally smaller during the text print areas, less than 0.08mm but enough to see and catch with a finger nail My thought is that when not printing the text, the printer has chance to get up to speed and perhaps overshoots slightly, when printing over the text areas it does not and therefor is marginally smaller. The gap on the top between the fill and the perimeter is still a mystery, I tried increasing the overlap slightly but to no avail. Any thoughts, tips etc would be appreciated To clarify, the BED will not exceed 55 Deg C, it is not in a chamber and is using only the provided Tronxy X5S parts I am using OctoPrint to run the job though and also to capture the images If you want this printer, click here https://www.gearbest.com/3d-printers-3d-printer-kits/pp_701647.html?lkid=12706085
More from this channel
-
2:18
Agilent U1272A vs U1273A Sunshine test
-
3:41
Agilent U1272A vs U1273A Indoor test
-
5:43
33622A #2 Review: PrepowerUp
-
11:57
Measuring Components with a squarewave, Pt 3 - The Math
-
6:03
RPI B+ and the EnOcean Sensor Kit Overview of Up Comming Blogs and Videos
-
3:36
TDR #5 RG6 Maths
-
11:37
TDR #6 UTP Measurement
-
9:58
Resistance Standard