Loose trailer springs
2,575 views · Published 8 July 2010 · 1:01 · Indexed 4 November 2026
Channel: NelsonStudios · 2010 · Autos & Vehicles
Getting ready for a trip to a Seattle surplus yard and was doing some trailer maintenance. I noticed the wheels clunked some so I pulled the caps to tighten the bearings. All the bearings were fine but I found that the axle tubes were loose on the perch. The way it is built it is not a simple matter of tightening them up. You can see how the brackets clamp the springs and the axle assembly separate, it is already drawn up as much as it will go. I need to find a way to shim them, I was thinking of using copper sheet. My thought is to bend up a 'U' shaped shim that will then crush into place when I tighten it down.
More from this channel
-
0:37
Creston Auction
-
4:06
Driving the small locomotive: Alder Gulch Shortline
-
2:11
Driving the locomotive: Alder Gulch Shortline No. 8
-
3:47
Dead Cow Pit
-
2:08
Underside of BNSF locomotive!
-
0:19
Urban Exploration: Boiler room
-
0:31
Old Milwaukee substation turntables
-
0:11
Urban exploration: Old Milwaukee substation