Short Stopper current limiter protection - What is it and How to Build for RC quadcopter or airplane
1,835 views · Published 1 January 2017 · 12:15 · Indexed 22 October 2026
Channel: Dave Merc Productions · 2017 · Science & Technology
The Short Stopper has become very popular for building quadcopters and RC airplanes for short circuit protection. Using a current limiting bulb such as a 12 volt automotive tail light bulb a simple device can be constructed to protect motors, ESC, battery and prevent props from spinning up. If a short occurs during building or testing the Short Stopper automotive bulb lights and limits the current to about 2 amps thus protecting the electronics and battery from electrical damage (as long as you use a 3S battery for testing). There is also the added benefit of the motors not having enough current make the props dangerous if they inadvertently spin up. A common everyday 1157/3157/4157/3057/4057/3357 automotive taillight bulb will flow approx 2A through the heavy filament, and another 450-500 mA through the lighter filament. If we connect them in parallel, we get a Current-Limiter in the 2.5A range. Switch that we used Catalog #: 2750613: https://www.radioshack.com/products/spdt-submini-sw STL 3D printer files for Short stopper box: http://www.thingiverse.com/thing:2009169 Disclaimer: - This is for three cell batteries only or 12volts (already mentioned in video). - Don't forget to unplug because a mistake of leaving the switch on could drain batteries. - This is the higher current version and some RC electronics could be damaged with 2.5 amps so check your aircraft for dead shorts with an ohm meter first (I do anyway), then do a low current test with a low current bulb (see RC groups thread below for low current info.) - With this version props could still spin-up on tiny quads that can fly on 2.5 amps so always remove props, - Don't use on projects that use 1 cell or 2 cell batteries or you may damage the aircraft, We are not responsible for damage caused by this device. You should also do a low current test first with a low current bulb. See RCgroups thread for more information. https://www.rcgroups.com/forums/showthread.php?2327875
More from this channel
-
0:11
Jon clone video.wmv
-
2:34
Magix Movie Edit Pro 15 (Hilighted Cursor AutoPan CamStudio).mov
-
0:39
jerry you're too loud 1.AVI
-
8:44
2010-08-01 Dmerc00 in his First RC Airplane Combat Session - McMAC 3rd Heat.AVI
-
3:42
Foamy Rc Electric Trainer Plane, Building and Testing Part 2
-
2:31
Smart Dart XS Slow Stick 720p HDTV 2010-09-19
-
2:06
2011-09-23 Cat Chasing, Pouncing and Attacking Deer
-
3:00
2012-01-07 Jon Flying Blade mCX Tandem Rescue Heli