Graham's DIY Jib crane update - the MKII
3,773 views · Published 20 April 2012 · 7:49 · Indexed 10 October 2026
Channel: Graham Houghton · 2012 · Howto & Style
Increasing the length of the jib to 48 inches needed the jib to be made from more rigid material to prevent sag of the jib on either side of the main pivot point. I wanted to use a thicker wall "U" section alumium profile but could not obtain any from local stockists. I decided to rivet 2mm thich x 20mm wide flat bar to the 1.5mm "U" section to improve the strength. I lightened the jib by substantially cutting out the top web of the profile as this is only used to prevent twist and side to side movement. The head has been modified to mount the camera below the centre of the front bracket to improve stability.
More from this channel
-
3:36
Foxgloves and Wild Orchids - Captured on the Samsung WB550
-
2:42
GH1 test clips
-
1:10
paddy shine (Manchester Busker) captured with Lumix GH1
-
9:22
Manchester Old with New Captured with the Panasonic GH1
-
5:10
Butterfies & Insects in Burgh Meadow
-
6:21
a low level light test video between the Lumix TZ7 and FZ38 (FZ35) cameras
-
6:13
Snowfall in Rivington ( A tribute to my Mother)
-
4:51
Winter at The Doffcocker nature Reserve, Bolton. Captured with the lumix fz38