DIY Twin Engine Tundra RC Plane Build - Part 3 (Installing Motors, Wing Servos, Tail Section)

1,794 views · Published 19 September 2018 · 12:33 · Indexed 16 November 2026

Channel: Dave Merc Productions · 2018 · Science & Technology

Watch on YouTube

DIY Twin Engine Tundra RC Plane Build - Part 3 (Installing Motors, Wing Servos, Tail Section) and testing differential thrust. https://youtu.be/wfvZpO-cgRo
You can build your own twin prop tundra using 3D printed nacelles designed by barndog726 (link below). In this video I install the motors on the 3D printed nacelles, Install the wing servos, install motor cables, finish the tail section and check the servos and the differential thrust.

Twin Tundra Build Part 1 here: https://youtu.be/6ltusxU6Su8
Twin Tundra Build Part 2 here: https://youtu.be/fJTWzTuW1TE
And The Introduction here: https://youtu.be/qVKOGMDyM2E
Crimping tool video: https://youtu.be/tyJAFQQf9fo

Parts you will need for the build:

HobbyKing Durafly Tundra Kit
https://hobbyking.com/en_us/durafly-tundra-1300mm-arf-orange-grey.html

3D Printed Nacelles bardog726 Thingiverse
https://www.thingiverse.com/thing:3092358

Foam-Tac or Fabric-Tac from Wal-Mart to glue on nacelles.

18 Gauge Silicone Wire to extend motor leads

Battery Turnigy Graphene 2200mAh 4S 65C Lipo Pack W/XT60

Servos 6x TGY-50090M Analog Servo 20T MG 1.6kg

APC 7x5 LP07050E Thin Electric Propeller
APC 7x5 LP07050EP Thin Electric Pusher Propeller

2x Motors SunnySky X2212-KV1400 II

2x ESC 30 amp 2-4s w/ 0.5 amp BEC (Afro)

FrSky X8R Receiver

FrSky FLVSS Lipo Voltage Sensor FRS3040611

XT60 Connectors RC Yellow

HXT 3.5MM CONNECTOR FOR MOTOR/ESC (12PC)
     https://hobbyking.com/en_us/individual-hxt-3-5mm-connector-for-motor-esc-12pc.html

RCgroups Thread
https://www.rcgroups.com/forums/showthread.php?2413887-Durafly-Tundra/page1462

More from this channel