Look Who it Was Random video

Mod: Pin-System Kamen Rider Belts

4,635 views · Published 3 February 2010 · 8:39 · Indexed 12 November 2026

Channel: CollectorShuki · 2010 · People & Blogs

Watch on YouTube

This was requested a few times, so here it is, and sorry for the delay. The request was to film the process I used to mod my Double Driver. Not wanting to unmod it to remod it again, I was planning on modding the Accel Driver.  However, because the Accel Driver uses a system of 3 holes and pegs rather then a pin...that became impossible, so SHF Ixa's arrival inspired the choice of the Ixa Belt.

Like I said, a "Pin-System" belt, is any belt where the plastic part of the belt connects to the fastener (the part that plugs into the main section of the belt)) via a pin. If it can swivel inside that piece, it's most likely held in by a pin. I know for a fact that Kiva, Ixa, DecDriver, and W Driver all use this method. It appears that if a belt is perminately hooked onto the base, it uses this system, while a belt that can come off entirely uses holes. The W Driver being a slight exception of course.

If you have any more questions toss em in the comments, I'll address them the best I can.

Check out my Flickr Photostream at: www.flickr.com/photos/shukuenshinobi
Check out my blog at: shukuenshinobi.wordpress.com

Enjoy! Please rate, comment, and subscribe!

More from this channel