New Ground Clamp & Wire Feed Fix for Mig Flux Welder

1,708 views · Published 12 February 2016 · 12:26 · Indexed 16 November 2026

Channel: syyenergy7 · 2016 · Education

Watch on YouTube

New Ground Clamp & Wire Feed Fix for Mig Flux Welder.
On this Northern Industrial mig/flux welder I am installing an  oversize 98% pure copper 200 amp welding ground clamp..  As an amateur welder it surprised me how much better my welds came out with the high quality 200 amp pure copper welding ground clamp.  I didn't think it would make much of a difference since the original welder ground clamp that came with it is in perfect condition.  It was not like I was changing out an old, corroded, worn-our welder ground clamp for a new welder ground clamp.   Obviously the welder ground clamps that come with the any new welder are marginal at best, because the 98% all copper welder ground clamp vastly improved the welding ability of this amateur welder.  It should greatly help me repair all the rest of the rust on this old El Camino by welding in new metal.  The 200 amp 98% copper welder clamp will improve the welds of any amateur welder.
The wire feed motor in the Mig welder runs at 24 Volts.  If you have a broken controller board and the wire feed motor is still good, you can still make it work by rigging up a battery and a rheostat. Otherwise a new controller board or the labor to fix the controller board will cost you as much as a brand new quality welder.
Here I am installing a 24 volt DC power supply to bypass the broken mainboard on the welder.  With a separate 24 volts power supply I can make the wire feed motor on the welder work again.  It's not a perfect fix, but it will enable the flux wire to feed again so that the mig/flux welder will function properly.  Many times you can repair your mig welder or flux welder without buying expensive replacement welder parts.

More from this channel