JBL D -131 Restore was close to a failure.
3,630 views · Published 5 January 2015 · 3:19 · Indexed 22 October 2026
Channel: maynardcat · 2015 · Music
I've had this JBL D-131 stored for many years in the same bad condition I found it in. I don't repair speakers and this project seemed doomed from the start. When I first recieved the new cone and spider, 20.00 in all including shipping, I inspected it. I left the box on the desk and left, when I returned Ingra, the cat, had pulled it off in the floor and had made a bed out of it speaker cone and all, making a dent in the cone to start with. I've recently been talking to the authorized JBL & Altec speaker service center here in town, and he cautioned me that the D-131 was difficult to re-cone even with the correct kit due to the very narrow tolerances in the voice coil gap, and warned me that my attempt at doing it this way wouldn't work and he was right it almost didn't. Gluing the cone and spider was difficult, then the old voice coil was slightly out of round by millimeters that I couldn't see, and guessed at where to apply pressure to try to make it perfectly round again. Then the wire broke off coming directly out of the voice coil and I decided that was it, that couldnt' be repaired. The next day with some needle nose pliers I pulled a round of the voice coil wire off the coil which gave me inches to use for soldering. I then had to attemp inserting the wire back in a millimeter indented area on the side of the voice coil, and I finally succeeded with that. I waited 3 days to glue the voice coil in not sure exactly how to align it as preserving the original aluminum dust cap eliminated the use of shims, but I felt the original dust cap directly glued to the voice coil would provide much more highs which it does, and it also helped keep the voice coil round, plus the glue was very tough and wasn't going to come off without possible damage to the sleeve. I managed to get it aligned to an extent, but the final alignment was with the gluing of the surround to the frame. I almost decided to give up on this, put it back on the shelf and try it again with the JBL re-cone kit, which is from 125.00 to 180.00. I didn't want to attempt that first, gambling with 20.00 worth of parts is one thing but close to 150.00 is another matter, and I could always go that route so I gambled with the 20.00 repair first, and It finally did pay off. The 7 inches of wire I pulled off the voice coil didn't make a lot of difference, it read 4.5 ohms before and about 5 afterwards. As far as sound goes I have no idea, it was beyond use when I got it and it's the only D-131 I have, nothing to compare it with.
More from this channel
-
3:11
Seeburg 1954 playing If that's the way you want it
-
2:52
Colony Capers by Scotty Lynn on the Hammond B3 Organ
-
3:22
Stranger on the shore -Buddy Merrill played on a 1954 Seeburg jukebox
-
3:15
Charmaine by Julia Lee and her Boyfriends played on 1957 RCA HI-FI
-
2:40
Ponytail by Muvva Guitar Hubbard played on a 1954 Seeburg jukebox
-
2:45
Antique Zenith Radio 1941
-
2:38
Til Then by Ray Peterson 1960 played on a 1956 Wurlitzer jukebox model 1900
-
1:46
Cats enjoying warm spring day 3-17-09