Designing of Plastic Products for Injection Moulding - Animation Less Than 90 b
3,753 views · Published 22 September 2015 · 0:20 · Indexed 22 October 2026
Channel: Dsource Ekalpa India · 2015 · Education
@dsourceindia Designing of Plastic Products for Injection Moulding is a course by Prof. Vijay. P. Bapat and Shiv Kumar Verma from IDC, IIT Bombay. This snap-fit has a 90° retaining angle for firm locking but can be disengaged using a pusher pin. For more information, visit https://www.dsource.in/course/designing-plastic-products-injection-moulding Write to us at [email protected] #IITBombay #IDCBombay #EngineeringDesign #DesignEngineering #OnlineLearning #EngineeringEducation #InjectionMoulding #PlasticDesign #AdhesiveBonding #PlasticAdhesives #JointDesign #MaterialScience #StressAnalysis #AdhesiveScience #PolymerEngineering #EngineeringLecture #EducationalVideo #DesignCourse #OnlineCourse #MechanicalDesign #BondingTechniques #PlasticsEngineering #ProductDesign #AdhesiveTypes #StressTypes #EngineeringMaterials
More from this channel
-
0:51
Naga Cane Basket Leg Making Process - Khophi Part 3
-
1:07
Naga Cane Basket Rim Making Process - Khophi Part 4
-
4:21
Product Drawing: Object & Shadow 01 by Sarita Chawdhari
-
8:25
Product Drawing: Object and Highlights by Sarita Chawdhari
-
6:53
Product Drawing: Object Sketch with Light & Shadow Effect by Ibynta Tiewsoh
-
1:58
Expo CD Workshop By Dr Ajanta Sen, IDC, IIT Bombay
-
1:00
Jakhoi and Khaloi - Making Process of Jakhoi Part 1
-
4:01
Jakhoi and Khaloi - Bamboo Bangle