2"X48" 1.5kW (2hp) Belt grinder test run

1,691 views · Published 12 September 2018 · 2:47 · Indexed 1 November 2026

Channel: Lapis Lignum · 2018 · Entertainment

Watch on YouTube

I've wanted a belt grinder for a while, after looking at what is available and doing lots of 2D CAD iterations I came up with this design.

Some inspiration was drawn from existing grinders but this design is as simple as I could make it, most parts are lasercut from 10mm mild steel (the "frame" is a single piece of plate that bolts to the motor, the idler wheels and tension arm bolt to the same plate, hopefully minimising alignment issues.

Off the shelf 50 X 5mm angle iron is used for the platen.

Still needs more development but it works pretty well now, I'm not sure the skateboard bearings will last very long but I can easily upgrade to wheels with larger axles and bearings.

The one piece design does have some limitations compared to a telescopic tube grinder but I can bolt a tool arm to the frame if I need this functionality.

The tracking mechanism is adjustable in two dimensions

Only the drive wheel is crowned.

Details

1.5 kW 3 phase B5 Flange and foot mount motor (Delta wired)

1.5kW single phase in three phase out variable frequency drive

 8" drive wheel

"70 X 51mm longboard" idler/tracking wheels

250N gas strut 

Belt speed at 50Hz (the VFD won't go higher without reprogramming it) is ~5850 surface feet per minute, or 107 Km/hr.

wheel offset is adjusted with washers.

More from this channel