1978 El Camino, Fixing RUST Part 3

706 views · Published 8 November 2015 · 21:50 · Indexed 21 October 2026

Channel: syyenergy7 · 2015 · Education

Watch on YouTube

1978 El Camino, Fixing RUST Part 3
Rust on the 1978 El Camino.  The first step is to evaluate where to start on the rust.  My plan is that I don't want to dissemble the car and I want to repair and replace a section of rusted out metal at a time.   I used a cut-off wheel to cut out all the all rotted out metal.  You can see why that area of the El Camino rusted out,, because it trapped a lot of dirt and debris and that kept water and moisture inside so that part of the quarter-panel could rust out from the inside out.  I used compressed air to blow out all the dirt and debris after I cut out all the rusty metal.  Then I used a small portable sandblaster, that costs only $20 to get the area inside the quarter-panel clean.   Then I chemically cleaned the area and then applied a special rust converter and primer all in one to make sure that all microscopic rust was stopped.  After that I applied some high heat paint, because I will be welding in that area and I don't want the paint to peel off due to welding sparks.  Then i used a flange tool and made a flange around the area when a replacement patch panel will be welded.  The replacement patch panel will sit flush with the rest of the quarter-panel due to the flange offset.
After I welding in the patch panel, I used a skim coat of 3M panel adhesive, part number 08115, to make sure any areas that were not completely welding were sealing from any water that could get in from the backside and cause rust again.

Chevrolet El Camino (Automobile Model),1978 El Camino,Fixing RUST Part 2,Start on Fixing RUST,used a flange tool and made a flange,special rust converter and primer,replace a section of rusted out metal,cut-off wheel to cut out all the all rotted out metal,why that area of the El Camino rusted out,patch panelfor rust,3M panel adhesive,part number 08115,cause rust again.

More from this channel