High Voltage Jumping Backwards Into a Diode Bank
3,723 views · Published 4 July 2009 · 6:01 · Indexed 18 November 2026
Channel: Aaron Murakami · 2009 · Science & Technology
A bench demonstration on the Gray tube arrangement. The high voltage output of an ignition coil is taken to the high voltage rod, jumps a gap to a low voltage rod backed by a bank of six reversed 1,000 volt diodes, and from there into a capacitor bank. He addresses the objection directly: many people believe nothing can jump backwards into the diodes, and he shows the capacitor bank climbing from around four volts to twenty six while the gap is being triggered. He then charges the same bank to over 1,100 volts and shows the discharge still crossing the gap, making the point that the high voltage finds ground regardless of what potential is already sitting there, because both sides share a common ground. The inductor is out of circuit throughout. https://emediapress.com https://emediapress.com/energytimes Posted 2009-07-04.
More from this channel
-
2:04
Sampler of RDT Generation II — PATHS Mind Energetics
-
6:45
Signing Up for Project One World — PATHS Walkthrough
-
3:38
The Positive Terminal Is Not Even Connected — Murakami-Gray
-
1:15
Ainslie Circuit: Oscillation in Resonance — Scope Footage
-
4:23
Pickup Coil Charges a Cap Above Battery Voltage — Ainslie
-
3:49
The Clean Ring Gives More Heat — Ainslie COP 17 Circuit
-
3:25
Ainslie Circuit: Oscillation That Never Settles at Zero
-
9:03
Ainslie Flop Mode: 80 V Back to a 25 V Battery — 2009