Dynamometer Wheel at 3.82 Inches: the Math Does Itself
1,927 views · Published 10 February 2013 · 6:32 · Indexed 23 October 2026
Channel: Aaron Murakami · 2013 · Science & Technology
Aaron Murakami machines a plastic pulley into an old-school dynamometer wheel for measuring the mechanical work coming off a shaft. The groove is cut so the wheel is 3.82 inches in diameter, giving exactly one foot of circumference, which reduces the foot-pound calculation to reading the spring scales on a leather belt looped over it. He shows measuring the diameter with an inexpensive long-jaw caliper rather than an expensive deep-jaw one, and points to Peter Lindemann's method for using it, noting it will fit a Bedini SG or any other shaft you want to measure so the mechanical output can be added to the electrical. Chapters 0:00 The wheel and the set screw 2:00 The belt and spring scales 4:31 Measuring it with a cheap caliper https://emediapress.com https://emediapress.com/energytimes Posted 2013-02-10.
More from this channel
-
2:04
Sampler of RDT Generation II — PATHS Mind Energetics
-
6:45
Signing Up for Project One World — PATHS Walkthrough
-
6:01
High Voltage Jumping Backwards Into a Diode Bank
-
3:38
The Positive Terminal Is Not Even Connected — Murakami-Gray
-
1:15
Ainslie Circuit: Oscillation in Resonance — Scope Footage
-
4:23
Pickup Coil Charges a Cap Above Battery Voltage — Ainslie
-
3:49
The Clean Ring Gives More Heat — Ainslie COP 17 Circuit
-
3:25
Ainslie Circuit: Oscillation That Never Settles at Zero