Charging Lithium Iron Phosphate — Peter Lindemann
4,112 views · Published 15 September 2014 · 7:16 · Indexed 23 October 2026
Channel: Aaron Murakami · 2014 · Science & Technology
Peter Lindemann introduces a line of solar charge controllers built specifically for lithium iron phosphate batteries. He is careful to separate the chemistry from lithium ion, which he says the chargers are still not intended for. The comparison he leads with is weight and capacity: a 10 amp hour lithium iron phosphate pack against a 12 amp hour lead acid battery of about the same capacity, with no liquid electrolyte, nothing to spill, low internal resistance and tolerance of being fully discharged and recharged repeatedly. The reason a dedicated charger is needed is the finishing voltage: four cells at 3.2 volts give 12.8 nominal and the pack completes its chemistry at about 14.8 volts, where a lead acid battery is taken to roughly 15.1 or 15.2. He demonstrates the unit holding the pack above 13.4 under load. https://emediapress.com https://emediapress.com/energytimes Posted 2014-09-15.
More from this channel
-
2:04
Sampler of RDT Generation II — PATHS Mind Energetics
-
6:45
Signing Up for Project One World — PATHS Walkthrough
-
6:01
High Voltage Jumping Backwards Into a Diode Bank
-
3:38
The Positive Terminal Is Not Even Connected — Murakami-Gray
-
1:15
Ainslie Circuit: Oscillation in Resonance — Scope Footage
-
4:23
Pickup Coil Charges a Cap Above Battery Voltage — Ainslie
-
3:49
The Clean Ring Gives More Heat — Ainslie COP 17 Circuit
-
3:25
Ainslie Circuit: Oscillation That Never Settles at Zero