Pull the Wire Off and the Tube Stays Lit — Ainslie Circuit
3,788 views · Published 24 September 2009 · 5:38 · Indexed 27 October 2026
Channel: Aaron Murakami · 2009 · Science & Technology
A short bench test on the Rosemary Ainslie circuit running on a 24 volt bank with the timer on a separate 6 volt battery. Instead of heating the resistor he takes the spike off the coil, which he reads at close to 700 volts, through a diode into a fluorescent tube and back to the top of the coil. The light is not bright, and he is candid that it is not impressive, but he shows he can keep it lit while bringing the shunt reading down from about 180 millivolts to around 60 by reducing the on time, having jump-started it at a higher level. The result he draws attention to is that disconnecting the return lead leaves the tube lit, making it a one wire effect, and that grounding it elsewhere makes no apparent difference. He suggests the reverse conduction of the MOSFET may be worth trying in other lighting circuits. https://emediapress.com https://emediapress.com/energytimes Rosemary Ainslie circuit, 2009 bench footage. Posted 2009-09-24.
More from this channel
-
2:04
Sampler of RDT Generation II — PATHS Mind Energetics
-
6:45
Signing Up for Project One World — PATHS Walkthrough
-
6:01
High Voltage Jumping Backwards Into a Diode Bank
-
3:38
The Positive Terminal Is Not Even Connected — Murakami-Gray
-
1:15
Ainslie Circuit: Oscillation in Resonance — Scope Footage
-
4:23
Pickup Coil Charges a Cap Above Battery Voltage — Ainslie
-
3:49
The Clean Ring Gives More Heat — Ainslie COP 17 Circuit
-
3:25
Ainslie Circuit: Oscillation That Never Settles at Zero