3 D printed 12v battery box part 2

253 views · Published 27 January 2018 · 5:49 · Indexed 6 November 2026

Channel: Not rocket science · 2018 · Science & Technology

Watch on YouTube

Do this at your own risk. 
Lithium ion batteries can catch fire or explode if overcharged or over discharged.
  I did a bit more work on the 18650 lithium ion battery box. I want the accessories that I use to be simple plug and play.  The battery box has a 2.1mm x 5.5mm jack. Some accessories can simply be plug into the jack for power. Then I made a double ended 2.1mm plug so I can connect the box through the plug to devices that has a 12v jack.
 I added a LED voltage meter so I can monitor the state of charge of the battery pack. The batteries I'm using are supposed to be protected cells but the battery pack should not be used without careful monitoring and needed to be recharged when the pack's voltage falls below 10v. You can limit the charging voltage to less than 4.20v if you want to extend the life of the batteries.
  In part 3 I will go into more detail on the assembly of this LOW DRAIN 12v battery box.
  
 Click here to subscribe to this channel: http://www.youtube.com/subscription_center?add_user=wtam69

More from this channel