1 watt LED dimmer driver

1,591 views · Published 9 October 2016 · 3:44 · Indexed 8 November 2026

Channel: Not rocket science · 2016 · Science & Technology

Watch on YouTube

Do this at your own risk. This is not a tutorial.

With higher power LEDs, you need a driver for it. Wouldn't it be nice if you can dim the LEDs as well without using complicated electronics to achieve this?
I used a 10K potentiometer as a driver and dimmer for a set of three 1 watt LEDs.  Initially, I added a 50 ohm resistor as the pot can be turned to a position where there is 0 resistance.  A 18650 lithium ion battery charged to 4.1v powered the 3 LEDs connected in parallel.  The 10K pot regulates the excess voltage and can also function as a dimmer control.  With the battery I was using, it was only able to put out 200mA, thereby minimizing the danger of delivering too much current to the LEDs.  
If you are using higher voltages, make sure you add a resistor to regulate the current when your pot is set to 0 resistance. The resistance value can be determined by the voltage to be regulated divided by the current draw of the LED,
  You can use drivers built to drive these higher power LEDs, but if you want to dim them as well, then you can try this option.

Click here to subscribe to this channel: http://www.youtube.com/subscription_center?add_user=wtam69

More from this channel