Ainslie Circuit: DC Coupling and a True Ambient Reference
143 views · Published 28 August 2009 · 10:00 · Indexed 8 November 2026
Channel: Aaron Murakami · 2009 · Science & Technology
All four channels of the Tektronix TDS3054C are shown set to DC coupling on the Rosemary Ainslie COP 17 heater circuit, and the RMS-to-DC-average spread at the load shunt is read off as 108.66 times. The second half covers temperature: an identical unpowered ceramic resistor sits inside the same enclosure as the load so that load temperature is compared against its own environment rather than room air. The 555 timer chip reads 25 C against a 19 C board, the power pot runs about 10 C above ambient, and the MOSFET stays at room temperature. Chapters 0:00 Scope set to DC coupling 3:46 Ambient reference resistor explained 7:07 Timer chip and pot temperatures https://emediapress.com https://emediapress.com/energytimes Rosemary Ainslie COP 17 circuit, 2009 bench footage. Recorded 2009-08-28.
More from this channel
-
2:04
Sampler of RDT Generation II — PATHS Mind Energetics
-
6:45
Signing Up for Project One World — PATHS Walkthrough
-
6:01
High Voltage Jumping Backwards Into a Diode Bank
-
3:38
The Positive Terminal Is Not Even Connected — Murakami-Gray
-
1:15
Ainslie Circuit: Oscillation in Resonance — Scope Footage
-
4:23
Pickup Coil Charges a Cap Above Battery Voltage — Ainslie
-
3:49
The Clean Ring Gives More Heat — Ainslie COP 17 Circuit
-
3:25
Ainslie Circuit: Oscillation That Never Settles at Zero