Dialing Ainslie Flop Mode From 40% Down to 20% — 2009
271 views · Published 13 August 2009 · 6:51 · Indexed 10 November 2026
Channel: Aaron Murakami · 2009 · Science & Technology
Gate resistance alone is used to set how much of the time the Rosemary Ainslie circuit spends in oscillation, taking the burst from roughly 40 percent of the cycle down to about 20 to 25 percent. The target is described as neither full oscillation nor pure pulsing but the flop between them. Practical bench advice: use ten-turn pots on off-time, on-time and gate, because single-turn pots are too coarse to hold the setting. Chapters 0:00 Finding the edge of flop mode 2:09 Ten-turn pots and the schematic 5:23 Duty cycle dialled down by resistance https://emediapress.com https://emediapress.com/energytimes Rosemary Ainslie COP 17 circuit, 2009 bench footage. Posted 2009-08-13.
More from this channel
-
2:04
Sampler of RDT Generation II — PATHS Mind Energetics
-
6:45
Signing Up for Project One World — PATHS Walkthrough
-
6:01
High Voltage Jumping Backwards Into a Diode Bank
-
3:38
The Positive Terminal Is Not Even Connected — Murakami-Gray
-
1:15
Ainslie Circuit: Oscillation in Resonance — Scope Footage
-
4:23
Pickup Coil Charges a Cap Above Battery Voltage — Ainslie
-
3:49
The Clean Ring Gives More Heat — Ainslie COP 17 Circuit
-
3:25
Ainslie Circuit: Oscillation That Never Settles at Zero