Makeshift amorphous panel repair

393 views · Published 26 September 2016 · 3:45 · Indexed 12 November 2026

Channel: Not rocket science · 2016 · Science & Technology

Watch on YouTube

Youtuber Xanataph has a solar panel that exhibit the same non charging problem as mine. His repair was to resolder the positive bus wire to the connecting positive wire.
My positive bus wire looked good but I ran out of options to repair this panel. I had previously taken out the blocking diode but that wasn't the problem.  With no other choice, I followed Xanataph's repair by chipping a corner of the glass backing where the positive wire meets the bus wire.  I then clean the old bus wire, solder a new piece of bus wire on top, then solder the positive red wire to it.  So far the repair has worked and I'm getting .72 short circuit amp and 22v open voltage. It seems the original estimate of 15 w is still achievable if can repair the cold solder problem.
  
  Click here to subscribe to this channel: http://www.youtube.com/subscription_center?add_user=wtam69

More from this channel