18.7 Volt Peaks Back Into the Battery, No Recovery Cell
4,704 views · Published 17 March 2010 · 2:47 · Indexed 19 November 2026
Channel: Aaron Murakami · 2010 · Science & Technology
A short bench test of a 555 timer and MOSFET circuit, using an IRFPG50 to chop a 12 volt 7 amp hour gel cell into an old ignition coil, lighting a fluorescent tube from the output. There is no recovery battery: only a front battery. Aaron Murakami points out that its average voltage is slowly climbing, from 12.55 toward 12.56, while the peak on the same battery is being pushed to 18.7 volts, and attributes this to the inductive kickback traveling backwards through the MOSFET's intrinsic diode as a recharging pulse. So the current pulse leaves the battery, lights the tube and returns to the same battery. He is explicit that he is not attempting efficiency testing and is only getting the circuit running, with a 0.25 ohm shunt in place to read current. https://emediapress.com https://emediapress.com/energytimes Posted 2010-03-17.
More from this channel
-
2:04
Sampler of RDT Generation II — PATHS Mind Energetics
-
6:45
Signing Up for Project One World — PATHS Walkthrough
-
6:01
High Voltage Jumping Backwards Into a Diode Bank
-
3:38
The Positive Terminal Is Not Even Connected — Murakami-Gray
-
1:15
Ainslie Circuit: Oscillation in Resonance — Scope Footage
-
4:23
Pickup Coil Charges a Cap Above Battery Voltage — Ainslie
-
3:49
The Clean Ring Gives More Heat — Ainslie COP 17 Circuit
-
3:25
Ainslie Circuit: Oscillation That Never Settles at Zero